Pleasant Hardware

I did some real world testing (i.e. print some objects with the modified firmware) with the I2C-LC-Display setup on my MakerBot.

Here’s another short movie of the display in action:

I cleaned up my modifications in the extruder controller firmware and pushed my changes to a branch on the makerbot/G3Firmware github repository. You find the modifications in the “zaggoLCD” branch.

Next up: Trying an alternative solution with the LCD connected to the motherboard’s I2C bus…

I did some real world testing (i.e. print some objects with the modified firmware) with the I2C-LC-Display setup on my MakerBot. Here's another short movie of the display in action: I cleaned up my modifications in the extruder controller firmware and pushed my changes to a branch on the makerbot/G3Firmware github repository. You find the modifications in the "zaggoLCD" branch. Next up: Trying an alternative solution with the LCD connected to the motherboard's I2C bus...

This entry was posted on Friday, November 27th, 2009 at 14:41 and is filed under Experimental, Hardware, MakerBot enhancements, Software. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.