Comments on: Maintenance http://pleasantsoftware.com/developer/3d/2009/11/11/maintenance/ 3D printing with MakerBot and other hardware Fri, 03 Feb 2012 16:22:04 +0000 hourly 1 http://wordpress.org/?v=3.3.1 By: freds http://pleasantsoftware.com/developer/3d/2009/11/11/maintenance/comment-page-1/#comment-12 freds Wed, 11 Nov 2009 16:37:40 +0000 http://pleasantsoftware.com/developer/3d/?p=64#comment-12 I have had the same coking problem. Its better to start at 210c and slowly ramp up the tempature, 240 is a widely reported tempature but it seems the termal conductivity for the thermistors vary widely. So if you use 240 as your starting point you might go through a series of jams. I have had the same coking problem.

Its better to start at 210c and slowly ramp up the tempature, 240 is a widely reported tempature but it seems the termal conductivity for the thermistors vary widely. So if you use 240 as your starting point you might go through a series of jams.

]]> By: Rick http://pleasantsoftware.com/developer/3d/2009/11/11/maintenance/comment-page-1/#comment-11 Rick Wed, 11 Nov 2009 03:00:20 +0000 http://pleasantsoftware.com/developer/3d/?p=64#comment-11 Zaggo - Enjoying following your progress. It reads like a good novel - action, anticipation, ... - and at the moment I get to play the villain! (by breaking your printruder) :) Rick Zaggo – Enjoying following your progress. It reads like a good novel – action, anticipation, … – and at the moment I get to play the villain! (by breaking your printruder) :)

Rick

]]>